DIY Packer Harness

[TrIIIy]

I’ve been researching packer harnesses online, and most of the good ones are pretty overpriced. So I decided to make one myself based on the Multicolor Packer Harness on TransguySupply.com. It’s basically a Full Monty-style harness that is supported by an elastic band that sits just below the waist. The part that holds the packer is made of the same kind of elastic, and it keeps the packer in place while still allowing some natural movement.

 

Here are instructions for how to make the harness:

 

I have a sewing machine, so the actual sewing was pretty simple. It could also be done by hand. For measurements, just wrap the elastic around yourself below your waist, at about the start of your pubic area. Make sure that the elastic is fairly tight, but not tight enough to restrict blood flow. Cut and sew the ends together. Lay the band flat on a table.

 

For the packer area, get your actual packer out and wrap elastic around the testes. Don’t make this part too tight, or they won’t fit. Cut that length of elastic and sew both ends to the band that you just made.

 

Next, sew a short strip of elastic to the middle of the packer area, just below the band. This will support the penis.

 

And you’re done! 
 

This harness style works best with non-stp soft packers, although I use mine with a soft silicone packer.

 

Happy crafting!

 

 

-Trey